Procedure For Using Key Operator Programs; Key Operator; Programs; Key Operator Programs - Sharp Laser Printer Operation Manual

Procedure for using key operator programs

The procedure for configuring a key operator program is explained below.
1 Press the [CUSTOM SETTINGS] key.
2 Touch the [KEY OPERATOR PROGRAMS]
key.
DEFAULT
LIST PRINT
SETTINGS
FAX DATA
SENDER CONTOROL
RECEIVE/FORWARD

KEY OPERATOR PROGRAMS

Use the numeric keys to enter the five-digit
3
key operator code number.
KEY OPERATOR CODE
Supplementary explanation of key operation for key operator programs
KEY OPERATOR PROGRAMS
INTERFACE SETTINGS
HEXADECIMAL DUMP MODE
A
ENABLE PARALLEL PORT
ENABLE USB PORT
A Check mark boxes are touch keys that show the status of selections. A box with a check mark means the
function is "on" (enabled) and an unchecked box means the function is "off" (disabled). Alternate touches of a
box will change the on/off status.
B The name of the program category or particular item to be set will appear on the touch key. A touch of the key
will select the item displayed.
C If the settings continue on the following screen (s), touch the
the screens. To return to the category selection screen, touch the [OK] key.
D The currently set numerical value is displayed.
E Numerical values can be set by touching the
The factory default
setting for the key
operator code is
indicated on page 2 of
the key operator's guide.
I/O TIMEOUT
PARALLEL PORT EMULATION
SWITCHING
USB PORT EMULATION
SWITCHING
B
and
6-3
KEY OPERATOR PROGRAMS
4 Touch the [PRINTER SETTINGS] key.
PRINTER
SETTINGS

KEY OPERATOR

CODE CHANGE
program explanations on
and then follow these steps to select a setting for
the program.
5 Make desired settings for the selected
program.
Select the desired program from the programs
shown on page 6-2.
Detailed descriptions for program settings start on
the next page.
6 Press the [CA] key to exit the program.
These keys and indicator are
available on setting screens that
require the entry of numerical
values.
OK
1/2
20
C
AUTO
AUTO
and keys to move back and forth through
keys.
Follow these steps to
select the program that
you wish to use.
In the following steps,
the setting screens for
the selected program
will appear. Refer to the
page 6-5 and following,
(1 999)
20
D E