For the User
This appliance complies with the following
73/23 - 90/683 (Low Voltage Directive);
89/336 (Electromagnetical Compatibility Directive);
90/396 (Gas Appliances)
93/68 (General Directives)
and subsequent modifications.
Instruction for the User
Hob Burners Control Knobs
The hob burners control knobs are situated on the hob
front panel. The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
! ! ! ! !
Lighting the Burners
For easier lighting, proceed before putting a pan
on the pan support.
Push the relevant knob down and turn it anti-clockwise
until it reaches the "maximum" position (
After lighting the flame, keep the knob pushed down
for about 5 seconds. This will allow the "thermocouple"
(Fig. 1 - lett. D) to be heated and the safety device to
be switched off, otherwise the gas supply would be
Then, check the flame is regular and adjust it as
If you cannot light the flame even after several attempts,
check the "cap" (Fig. 1 - lett. A) and the "crown" (Fig.
1 - lett. B) are in the correct position. To put the flame
out, turn the knob to the symbol ".
When switching on the mains, after installation or
a power cut, it is quite normal for the spark
generator to be activated automatically.
In the absence of electricity, ignition can occur without
the electrical device; in this case approach the burner
with a flame, push the relevant knob down and turn it
anti-clockwise until it reaches the "maximum" position.
Always turn the flame down or put it out before
taking the pans off the burner.
For the Installer
ELECTROLUX HOME PRODUCTS ITALY S.p.A.
Viale Bologna 298 - 47100 FORLI' (Italy)
triple crown burner
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple