WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
Page 3
Installation During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction. If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit.
CONTENTS Installation Positioning Cleaning the interior Instructions for totally built-in appliances Electrical connection Technical specification Operation Temperature regulation Fresh food refrigeration Movable shelves Positioning the door shelves Defrosting Maintenance Periodic cleaning Periods of non-operation Interior light Customer service and spare parts...
INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock Important (latch) on the door or lid, be sure to make that It is essential that the appliance be connected to an spring lock unusable before you discard the old efficient earth tap.
Instructions for totally built-in appliances Fig. 1 50-min. cm Dimensions of the recess Height 1225 mm Depth 550 mm Width 560 mm The appliance’s door has been locked in position min. for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom.
Page 7
Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance Fig. 3 hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position.
Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 7 and mark Fig. 6 the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws.
Operation Fresh food refrigeration Insert the plug into the wall socket. To obtain the best performance: Open the refrigerator door and turn the thermostat do not store warm food or evaporating liquids in the knob, clockwise, beyond the «O» (STOP) position. refrigerator;...
Movable shelves Fig. 9 The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 Fig. 10 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height.
MAINTENANCE Interior light Unplug the appliance before carrying out any maintenance operation. The light bulb inside the refrigerator compartment can Warning be reached as follows: This appliance contains hydrocarbons in its cooling unscrew the light cover securing screws; unit; maintenance and recharging must therefore only unhook the moving part by pressing it as shown in be carried out by authorized technicians.
Need help?
Do you have a question about the ER 7335 I and is the answer not in the manual?
Questions and answers