USING REMOTE CONTROL UNIT
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
Use the RM-V700U remote control unit to perform this
Set the Power Switch to "PLAY".
FIND EDIT-OUT POINT
Play back the tape, locate the Edit-out point and
press PAUSE on the camcorder or the remote
Press and hold COUNTER R/M for more than
1 second to reset the tape counter, then press again
for less than 1 second and make sure "M" appears.
FIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE exactly at the point
where the new scene should start.
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. The Insert mode
is engaged. When the scene the camcorder is aimed
at appears on the screen, go to the next step.
BEGIN INSERT EDITING
Press START/STOP. When the counter reaches
"0:00:00", editing stops automatically and the
camcorder enters the Insert-Pause mode.
END INSERT EDITING
After step 5, Retake (
The tape may stop slightly before or after the desig-
nated end point, and noise bars may appear. Neither
indicates a defect in the unit.
Only video signal is recorded in the Insert Editing
pg. 17) can be performed.