KitchenAid KHMS105E Service Manual page 60

MEASURING MICROWAVE
POWER OUTPUT USING THE
IEC-705 RATING STANDARD
When determining the microwave oven's power
output using the IEC-705 rating standard, the
following conditions must be met:
• When making microwave power output mea-
surements, the oven is supplied with its
rated line voltage, and operated at its maxi-
mum power output setting with a load of
1000 (±5) cc of potable water.
• The water is contained in a cylindrical boro-
silicate glass vessel having a maximum
material thickness of
diameter of approximately 7.6 " .
• The oven and the empty vessel are at ambi-
ent temperature prior to the start of the test.
• The initial temperature of the water is 10˚C
±2˚ (50˚F). It is measured immediately be-
fore the water is added to the vessel. After
addition of the water to the vessel, the load
is immediately placed on the center of the
shelf, which is in the lowest position, and
the microwave power switched on.
1 / " and an outside
8
• The time (in seconds) for the temperature of
the water to rise by a value of 10˚C ±2˚ is
measured. The initial and final water tem-
peratures are selected so that the maximum
difference between the final water tempera-
ture, and the ambient temperature, is 5˚C.
• The microwave power output (in watts) is
calculated, using the following formula:
(L) 4187 (∆T)
P =
L = time (in seconds).
P = microwave output power.
(∆T) = temperature rise.
• Microwave power output is measured with
the oven operating at full power. The mag-
netron filament heat-up time (approximately
2-seconds) is not included.
• The water is stirred to equalize the tempera-
ture throughout the vessel, prior to measur-
ing the final water temperature.
• Stirring devices and measuring instruments
are selected to minimize the addition or
removal of heat.
3-18
T1