Generac Power Systems Digital Controller R-200A Technical Manual: Table Of Contents

Generac power systems digital controller technical manual.
Hide thumbs
Safety Rules ........................................ Inside Front Cover
General Information ......................................................... 2
Introduction ........................................................... 2
Generator Operation .............................................. 5
Engine Timing ........................................................ 5
Utility Failure ......................................................... 5
Manual Mode ...................................................... 5
Auto Mode ........................................................... 5
Exercise Mode ..................................................... 5
Utility Restored ...................................................... 5
Initial Cranking ...................................................... 5
Active Alarm ........................................................... 6
Re-crank ................................................................ 6
Normal Exercise Mode ........................................... 6
Low Speed Exercise ............................................... 6
Auto Start .............................................................. 6
Manual Start .......................................................... 7
System Ready (Green LED Indicator) .................... 7
Low Battery (Red LED Indicator) ........................... 7

Table of Contents

Low Coolant Level (Flashing Red
High Coolant Temp LED Indicator) ..................... 7
Overspeed (Red LED Indicator) ............................. 7
RPM Signal Failure
(Flashing Red Overspeed Indicator) .................... 8
RPM Signal Failure During Running .................... 8
Overcrank (Red LED Indicator) ............................. 8
Alarm Cancel ......................................................... 8
Engineered Transfer Switch
(2-wire Start GTS Mode) ..................................... 9
Voltage Regulator Adjustment .............................. 10
R-200A J1 Connector (23 Pin,
Gray=1800 rpm, White=3600 rpm) .............. 11
2A and 10A Battery Chargers ............................... 11
2A, 12VDC Battery Charger .............................. 12
10A, 12VDC Battery Charger ............................ 12
Notes ................................................................................... 13
Table of Contents
R-panel Technical Manual
AUTHORIZED SERVICE
DEALER LOCATION
To locate the nearest AUTHORIZED
SERVICE DEALER, please call this number:
1-800-333-1322
DEALER LOCATION INFORMATION
CAN BE OBTAINED AT THIS NUMBER,
or visit the website at www.generac.com.
1

Advertising

Comments to this Manuals

Symbols: 0
Latest comments: