Checking The Parking Brake; Adjusting The Clutch Wire; Adjusting The Throttle Wire; Replacing The Air Filter - Husqvarna Rider 112C Operator's Manual

Checking the parking brake

Check that the brake is correctly adjusted by placing the
machine on a slight downhill slope with the clutch disengaged
and activating the brake.
When the machine does not stand still, the brake should be
adjusted.
Adjusting the brake (112C)
1 Remove the left side cover on the rear body with 1 screw.
2 Loosen the locking nuts (1).
3 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
4 Tighten the locking nuts (1) after adjustment.
Adjusting the brake (112C5)
1 Remove the left side cover on the rear body with 1 screw.
2 Loosen the locking nuts (1).
3 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
4 Tighten the locking nuts (1) after adjustment.
Adjusting the clutch wire (112C5)
1 Remove both side covers on the rear body.
2 Loosen the locking nuts (1).
3 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
4 Tighten the locking nuts (1) after adjustment.
20 –
English
Maintenance
2
1
1

Adjusting the throttle wire

The throttle cable may need to be adjusted, if the engine does
not respond as it should when accelerating, if it produces
black smoke or maximum revs are not reached.
1 Release the clamping screw that secures the wire casing
and set the choke control to maximum choke.
2 Pull the choke wire casing to the far right and tighten the
clamping screw.
3 Pull back the throttle to the full throttle position and check
that the choke is no longer actuated.
Replacing the air filter
If the engine seems to lack power or does not run smoothly
this may be because the air filter is clogged. It is therefore
important to replace the air filter at regular intervals (see
Maintenance/Maintenance Schedule for the correct service
interval).
Replace the air filter as follows:
1 Open the engine cover.
2 Loosen the knobs holding the filter cover in place and
remove it.
3 Remove the air filter cover.
4 Lift out the air filter cartridge from the fan housing.
IMPORTANT INFORMATION
Do not use compressed air to clean the paper filter.
Do not oil the paper filter. They must be fitted dry.