The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
Check the engine's oil level
Check the engine's cooling air intake
Check the steering wires
Check the brakes
Check the battery
Check the safety system
Check nuts and screws
Check for fuel and oil leakage.
Clean around the silencer
Change engine oil
Check the cutting deck
Check the tyre pressures.
Lubricate joints and shafts
Check the V-belts
Checking and adjusting of throttle wire
Replace the air ﬁlter
Replace the fuel ﬁlter
Replace the spark plug.
Check the fuel hose. Replace if necessary .
First change after 8 hours. When operating with a heavy load or at high ambient temperatures, replace every 25 hours.
and replace the ﬁlter more often in dusty conditions.
by authorised service workshop.
X = Described in this operator's manual
O = Not described in this operator's manual
WARNING! No service procedures must be
conducted on the engine or cutting unit
The engine is switched off.
The ignition key is removed.
The ignition cable has been removed from
the spark plug.
The parking brake is applied.
The cutting unit is disengaged.
If the machine is used daily it should be lubricated twice a week.
At least once a
Maintenance interval in