Table of Contents
Advertisement
Upflow / Horizontal Furnace Filters
The Upflow/Horizontal furnace when installed horizontally re-
quires a horizontal filter kit. The filters may be located remote
to the furnace or in the return air duct near the furnace. Check
with your dealer for the location of your filters.
An upflow/horizontal furnace in horizontal return air filter
application, as shown, features two 16" x 20" x 1" filters in the 17-
1/2", 21" and 24-1/2" wide furnace cabinets.
UPFLOW/HORIZONTAL WITH FILTER KIT
To replace filters, remove the filter access door, lift the filter from
the lower bracket and shift the filter to the side to free the top
filter from the bracket and slide the filters out through the filter
access door. After cleaning, replace the filters in the same
manner making sure that the filters are secured in place in both
top and bottom filter brackets. Replace filter access door.
Air filters may also be located outside of the furnace using a
remote filter grille. The filter grille could be in a hallway, wall,
or in the ceiling. Check with your dealer for the exact location of
your filter and the method of changing the filters.
UPFLOW (Vertical) FILTER TABLES
REQUIRED FILTERS - BOTTOM
CABINET WIDTH
FILTER QUANTITY & SIZE
17-1/2"
1 - 17" X 25" X 1"
21"
1 - 20" X 25" X 1"
24-1/2"
1 - 24" X 25" X 1"
REQUIRED FILTERS - SIDE **
CABINET WIDTH
FILTER QUANTITY & SIZE
17-1/2"
1 - 17" X 25" X 1"
21"
1 - 20" X 25" X 1"
24-1/2"
1 - 24" X 25" X 1"
** ON UPFLOW 5 TON AIRFLOW MODELS, IF THE
AIRFLOW REQUIREMENT EXCEEDS 1800 CFM, THESE
OR
MODELS WILL REQUIRE FILTERS ON BOTH SIDES
1
OR
SIDE AND THE BOTTOM,
JUST THE BOTTOM
Downflow/Horizontal furnaces are factory supplied with 2 stan-
dard size permanent type air filters which may be located remote
to the furnace or in the return air duct. Check with your dealer
for the location of your filters.
A downflow/horizontal furnace return air filter application, as
shown, features two 14" x 20" x 1" filter in the 17-1/2" wide
furnace cabinets; or two 16" x 20" x 1" filter in the 21" and 24-1/
2" wide furnace cabinets.
DOWNFLOW FILTER
A downflow/horizontal furnace return air filter application, as
shown, features two 14" x 20" x 1" filter in the 17-1/2" wide
furnace cabinets; or two 16" x 20" x 1" filter in the 21" and 24-1/
2" wide furnace cabinets.
DOWNFLOW/HORIZONTAL FILTER
DOWNFLOW (Vertical) FILTER TABLE
REQUIRED FILTERS - DOWNFLOW
CABINET WIDTH
FILTER QUANTITY & SIZE
17-1/2"
2 - 16" X 20" X 1"
21"
2 - 16" X 20" X 1"
24-1/2"
2 - 16" X 20" X 1"
Page 3
- Quick Links:
- The Problem Solver
- Maintenance Information
Hide quick links:
Advertisement
Table of Contents
