Description of the cooker hood
The cooker hood
3. Grease filter
4. Work light
5. Control panel
The following are included with the cooker hood:
Template for mounting: Template for mounting
on wall and under cupboard (printed on
Mounting set: 4 pcs 4x60 mm screws, 4 pcs
5x30 mm screws, 4 pcs M5x30 mm screws, 4
pcs 5,3x15 mm washers, 4 pcs 5,3x10 mm
washers, 4 pcs M5 mm nuts, 4 pcs of wall dow-
els, 4 pcs spacers, 4 pcs plastic covers, 2 pcs
Cold air valve.
Following is ordered from retailer:
Venting kit: When the cooker hood is to be con-
nected to an evacuation channel use the venting
kit containing one ventilation pipe, one roof
connecting metal flange and two clamps.
PNC 391 414 201.
LONG LIFE carbon filter: The carbon filter is to
be used when the hood is connected to the
recirculation system. For new installations: PNC
391 834 201 (50 cm), 391 834 200 (60/70 cm). .
Venting grid: Venting grid for recirculation. PNC
391 433 101.
There are two possible systems:
Extraction of air to outside using optional
venting kit and evacuation duct.
Recirculation using optional carbon filter.
The cooker hood cannot be connected to flues
of other appliances that run on energy sources
other than electricity. Please, keep to the
provisions of official directives regarding the
question of fumes discharge.
Use the carbon filter. When you use the carbon
filter, the air is purified within the cooker hood
and recirculated back into the room, so heated
air is not lost. It can be a good idea to use the
carbon filter in winter and normal air extraction
to a duct in summer.