Di100 Configurations; Tapping Signal From The (Bass) Guitar - Behringer ULTRA-DI D|100 User Manual

11 ULTRA-DI DI100 User Manual
◊ O nly use the -20 dB switches if you are sure the ULTRa-DI is clipping (overloading)
and not your mic pre-amp. always use as little attenuation as possible to get the
best possible signal-to-noise ratio.
OUTPUT
. This is the balanced microphone level output of the ULTRA-DI. Connection to the
(6)
microphone input should be made with a standard high quality balanced cable.
◊ Never connect pin 2 or 3 to pin 1 and never disconnect the shield from pin 1,
or the unit will not work on phantom power.
Use the grOUNd LIFT switch to either connect the ground of input and output or keep
(7)
them completely separate. Depending on the grounding of the connected devices
linking or disconnecting will reduce hum or prevent ground loops. grOUNd LIFT ON
means no interconnection.
BaTTery cOmParTmeNT
(8)
the 9 V battery. When the ULTRA-DI is switched on battery power the LED blinks, when it
stops blinking it is time to change the battery.
2.

DI100 Configurations

The next section will show several different ways the ULTRA-DI can be hooked up.
2.1

Tapping signal from the (Bass) guitar

In
Fig 2.1: Guitar  DI  Guitar Amp/Mixer
. Loosen the screw to open the compartment and to replace
Out
Link
Out
DI100
Microphone Input