Noise After Ink Installation; Software Installation Problems; Solving Network Problems - Epson XP-211 User Manual

Noise After Ink Installation

If you hear noises from your product after installing ink, check the following:
• The first time you install ink cartridges, the product must prime its print head. Wait until priming
finishes before you turn off the product, or it may prime improperly and use excess ink the next time
you turn it on. Your product is finished priming the print head when the
• If the product's print head stops moving or making noise, and the charging process has not finished
after approximately 5 minutes, turn off your product. Turn it back on and check to see if charging is still
in progress. If it is still in progress, contact Epson for help.
Parent topic:
Related topics
Replacing Ink Cartridges

Software Installation Problems

If you have problems while installing your product software, try these solutions:
• Make sure your product is turned on and any necessary cables are securely connected at both ends. If
you still have problems installing software, disconnect the cable and carefully follow the instructions on
the Start Here sheet. Also make sure your system meets the requirements for your operating system.
• Close any other programs, including screen savers and virus protection software, and install your
product software again.
• In Windows, make sure your product is selected as the default printer and the correct port is shown in
the printer properties.
• If you see any error message or your software does not install correctly in Windows, you may not have
software installation privileges. Contact your System Administrator.
Parent topic:
Related concepts
When to Uninstall Your Product Software
Related references
Windows System Requirements
Mac System Requirements

Solving Network Problems

Check these solutions if you have problems setting up or using your product on a network.
Solving Setup Problems
Solving Setup Problems
142
power light stops flashing.