Section 2 - Installation; Location And Support - Generac Power Systems 00941-4 Owners And Installation Manual

2.1

LOCATION AND SUPPORT

◆
2.1.1 GENERATOR LOCATION
The most desirable location for the generator set is
between the vehicle's main frame members However,
this is seldom possible. Most units must be installed
on the side of the vehicle and are difficult to reinforce.
Many recreational vehicles have been factory
equipped with an area for the generator set. Some
vehicles may even have a generator compartment,
provided by the vehicle manufacturer.
Plan the generator location based on the following:
• The generator set must be installed on a framework
that is part of the recreational vehicle, as outlined in
the paragraph entitled "Generator Support."
• The location must provide an access opening that
is large enough to permit generator removal
(unless the generator is to be removed from under-
neath the supporting framework.
• The location must provide easy access to frequently
serviced components, such as filters, oil drains,
spark plugs and other common maintenance parts.
• The location must provide sufficient room to allow
minimum clearance of at least 1 inch between all
sides and 1-1/2 inches on top of the generator. If
sound insulation is to be used on compartment
walls and ceiling, the minimum recommended
applies to the space between the generator and
such insulation.
• The location must provide adequate cooling and
ventilating air flow for the generator without a
great deal of work and expense.
◆
2.1.2 GENERATOR SUPPORT
The generator must be securely attached to a metal
framework that has been made part of the vehicle
frame structure by bolting or welding. The metal
framework on which the generator will rest and
which will restrain the generator set should consist of
at least two horizontal beams. These beams should
consist of (a) 1-1/2 inch square, 11 gauge steel tubing
OR (b) 1-1/2 inch, 11 gauge angle iron. A typical sup-
porting frame with horizontal support tubing, is
shown in Figure 2.1.
The generator can be installed so that it sits on top of
the horizontal support tubing, if the vehicle design
permits. Another method is to suspend the generator
below the horizontal support tubing by means of suit-
able, structurally sound metal framework. The fol-
lowing general rules apply:
• Vehicle construction MUST be capable of support-
ing the weight of the generator.
• Whether the generator is mounted above the hori-
zontal support tubing or suspended below the tub-
ing, the supporting frame used must be structural-
ly sound.
Section 2 – Installation
IMPACT-36 plus II Recreational Vehicle Generator
• If the generator cannot be bolted directly to the
supporting frame or support tubing, consider
using additional tubing, angle brackets or other
supports to give the supporting frame sufficient
strength.
Figure 2.1 —Typical Horizontal Support Frame
◆
2.1.3 SUSPENDED MOUNTING
If the generator will be suspended below the horizon-
tal support tubing, the suspension method used with
the vehicle frame members must have the following:
(a) be able to support the weight of the generator; and
(b) provide sufficient restraint for the generator. One
typical suspended mounting system is shown in
Figure 2.2. The location of a suspended mounting
system must be carefully planned, keeping the fol-
lowing general rules in mind:
• Protect the generator against road splash and
debris. Baffles or splash guards may be required
to protect certain areas of the generator. To make
sure the generator is adequately protected, road
test the installation through mud, water and slush.
Figure 2.2 — Typical Suspended Mounting
• The installer must make certain that selected loca-
tion will permit adequate cooling and ventilating
air flow to be supplied.
System
Generac ® Power Systems, Inc. 19