Safety Requirements - Husqvarna 5524SB Owner's Manual

SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
THROTTLE
/ ENGINE
CONTROL
POWER
RECOIL
CORD
STARTER
PLUG
HANDLE
PRIM ER
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AU GERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for start ing the
en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle/engine control - used to se lect either FAST or
SLOW engine speed and to STOP the engine.
OPERATION
ENGINE OIL CAP
WITH DIPSTICK
FUEL
SHUT-OFF
VALVE
DISCHARGE
CHUTE
ELECTRIC
OIL DRAIN PLUG
START
BUTTON
CLEAN-OUT TOOL
AUGER
CONTROL
LEVER
DRIVE SPEED
CON TROL LEVER
GAS O LINE
FILLER
CAP
CHUTE
DE FLEC TOR
FIG. 8
Choke control - used for starting a cold engine.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di-
rec tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
8
DISCHARGE CHUTE CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LIGHT
HANDLE
KNOB
MUF FLER
TOOLBOX
SKID PLATE