Download  Print this page

Installation; Positioning; Water Inlet; Water Drainage - Electrolux ESF236 Instruction Book

Hide thumbs

Advertisement

Table of Contents

Installation

Positioning

The dishwasher is intended to be installed on a kitchen
drainer or worktop. To function properly, make sure that
the appliance is level. Its height can be adjusted with the
adjustable feets (8 mm each).

Water inlet

The temperature of the water supply should not exceed
65° C and the pressure should be between 50-1000 kPa
(0,5 - 10 bar).
It is important to have a tap or stopcock, positioned close
to the dishwasher and with easy access. Special mixer
taps with dishwasher connections are available, as well as
adaptors for older mixer taps. Connect the inlet hose to a
tap with a 3/4" pipe thread. If necessary, use the restric-
tor (1/2") supplied.
The inlet hose must not be joined onto any form of extension
hose. If it is too short, the entire hose must be replaced
with a longer high-pressure hose, specially designed for
the purpose. The end of the hose, which is connected to
the dishwasher can be turned in any direction. Loosen the
retaining nut, turn the hose, then retighten the nut.
Check that the nut and all other connections
are tight before the machine is moved into
position.
Use only the inlet hose supplied to the dish-
washer, do not reuse the old inlet hose.

Water drainage

Place the discharge hose over the sink as illustrated.
It must not at any point be higher up than 75 cm over the
surface which the dishwasher is standing on. If it runs hig-
her, operation of the dishwasher might be impaired.
It is also important to ensure that the inside diameter of
the hose is not less than 13 mm at any point. If the
discharge hose is too long, it can easily be cut to the right
length.
1. Cut the hose to a suitable length, using a sharp
knife.
2. Fit the elbow supplied onto the end of the hose.

Electrical connection

The dishwasher is supplied with a lead and electrical plug
for connection to a 230 V earthed wall socket, which
should be easily accessible and protected by a 10 A fuse.
Before any work is carried out on the dishwas-
her, it must be isolated from the electric mains
supply, for example by removing the plug from
the wall socket.
Permanent electrical installation must be carri-
ed out by an authorised electrician or compe-
tent person.
- 11 -

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Esf 236