Power Supply - Electrolux ESF2420 Instruction Book

Installation

Power supply

The dishwasher is supplied with a lead and electrical
plug for connection to a 230 V, 13 A earthed wall
socket. Before any work is carried out on the dish-
washer, it must be isolated from the electric mains
supply, for example by removing the plug from the
wall socket.
Permanent electrical installation must be
carried out by an authorised electrician or
competent person.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should
this safety measure not be observed.
The appliance should not be connected to the
electrical supply by means of an extension cable.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off and
the appropriate plug fitted.
Remove the fuse from the cut off plug.
Important: The plug must still be accessible after
the appliance has been installed.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
If you fit your own plug, the colours of the wires in the
mains lead of your appliance may not correspond
with the markings identifying the terminals in your
plug, proceed as follows:
Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter
«E» or the earth symbol
yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter «N» or coloured
black.
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter «L» or coloured
red.
The plug moulded onto the lead incorporates a fuse.
For replacement, use a 13 amp BSI362 fuse.
Only ASTA or BSI approved fuses should be used.
- Earth
- Neutral
- Live
or coloured green and
GREEN & YELLOW
BLUE
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard. Ensure
that the cut off plug is disposed of safely.
- 18 -
13 AMP FUSE
BROWN
CORD CLAMP