9.1 Cleaning the filters
9.2 Cleaning the spray arm
9.3 External cleaning
Clean the appliance with a moist soft
The appliance does not start or it stops
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
• The indicator of the set programme
• The end indicator flashes 1 time in-
Turn the filter (A) counterclock-
wise and remove it.
Remove the filter (B).
Wash the filters with water.
Put the filter (B) to its initial po-
Put the filter (A) into position in
filter (B). Turn it clockwise until
An incorrect position of the
filters can cause bad
washing results and dam-
age to the appliance.
Turn the nut counterclockwise.
Remove the spray arm.
Clean the holes.
If the holes in the spray arm are clogged,
remove remaining parts of soil with a thin
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
With some problems, different indica-
tors flash continuously or intermit-
tently at the same time to show an
The appliance does not fill with water.