• Consult the dealer or an experienced radio/TV technician for help. To remove the batteries from your equipment or remote control, reverse the procedure NOTE: Changes or modifications not expressly approved by Harman Kardon could void described for inserting batteries in the owner’s manual.
It will help ensure that the connections you make are correct. In addition, a few minutes spent learning the functions of the various controls will enable you to take advantage of all the power and refinement the SB 30 is able to deliver.
TV, disc player or cable/satellite tuner here. AC Fuse holder: The SB 30 CNTR is factory-equipped with a T4AL/250V AC fuse (110 – NOTE: You can connect three different source components to the three input connectors.
Page 5
SB 30 Connections and Controls Soundbar Top-Panel Controls Soundbar Status LEDs The soundbar has three LED indicators located behind the grille, as shown in the illustration below. Power Surround Volume Source Dolby Button Mode Down/Up Selector Volume Button Buttons Button...
SB 30 Connections and Controls Subwoofer Controls Power LED (on top of unit) Phase This area is designed to become Switch quite warm during normal operation Volume RISK OF ELECTRIC SHOCK RISK OF ELECTRIC SHOCK RISK OF ELECTRIC SHOCK Control...
SB 30 Remote Control Functions and Placing the Soundbar and Subwoofer Remote Control Functions Wall-Mounting the Soundbar If your TV is attached to a wall, you can use the included wall-mount brackets to mount the soundbar on the wall directly below the TV screen.
We recommend setting the component’s digital output to “Bitstream” so it will send Dolby Digital and DTS bitstreams to the SB 30 CNTR for decoding. This will ® ® produce better results when using the Virtual and HARMAN Wave surround modes (see Surround Modes , on page 11).
Page 9
Power switches set to “On” all the time. If you will be away from home for 1. Connect the supplied AC power cord to the SB 30 CNTR’s Power Cord connector and to an extended period of time, or if you will not be using the system for an extended period, a working unswitched wall outlet.
Page 10
In the unlikely event that you encounter interference when operating the system, or if you have more than one SB 30 system in operation, you may change the channel at which soundbar or on the remote control. Pressing the Power button while the soundbar is on the wireless system operates.
TV’s owner’s manual to find out how to do it. If there is no way to turn your TV’s speakers The soundbar’s Status LEDs glow blue to indicate the active surround mode: off, you can adjust your TV’s volume so that the SB 30 system will always supply most of the sound: Stereo 1.
Page 12
SB 30 Using Your Soundbar Speaker System Dolby Volume Stereo: The Stereo mode reproduces the input signal in conventional two-channel stereo, utilizing the soundbar’s left and right speakers. Digital equalization and digital crossover Your soundbar implements Dolby Volume processing, which can improve the audio...
SB 30 Specifications Specifications SB 30 System Frequency response: 40Hz – 20kHz SB 30 CNTR Soundbar Low-frequency transducers: Six x 2" (51mm) cones High-frequency transducers: Seven x 1" (25mm) domes Amplifier power: 40 watts x 4; 10 watts x 7 Power requirement: 110V –...
SB 30 Troubleshooting Troubleshooting If your SB 30 system isn’t performing the way you think it should, check to see if the problem is covered in this section before calling your dealer or contacting a Harman Kardon representative. Problem Solution The soundbar does not turn on (the Power LED is off): •...