Download  Print this page

Building In - Electrolux EHG 679 B Instruction Booklet

Hide thumbs

Advertisement

Building In

Building over a cupboard or drawer
If the hob is to be installed above a cupboard or
drawer it will be necessary to fit a heat resistant board
below the base of the hob on the underside of the
work surface.
1
ON/OFF SWITCH
FLEX
OUTLET
FO 0763
Building over a kitchen unit with door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the
bottom of the hob which can be heated when it is
operated. The recommended solution is shown in
diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.
Fitting the hob to the worktop
Before fitting the hob into the cut out, an adhesive
seal must be fitted to the underside outside edge (Fig.
3) of the hob. It is essential that no gaps are left in
this seal in order to prevent spillage near the hob
seeping into the cabinet below.
1) Remove the pan supports, the burners caps
and crowns and turn the hob upside down,
taking care the ignition candles are not
damaged in this operation.
2) Place the sealing gasket all around the glass
top edge as shown in diagram 4.
3) Fit the hob in the cut out and push it down
until the glass top and the working top make
contact, as shown in diagram 5.
It is also recommended to carry out the electrical
connection to the hob as shown in diagrams 1 and 2.
2
ON/OFF SWITCH
FLEX
OUTLET
FO 0764
3
a
60
b
FO 1013
Dimensions are given in mm.
FO 2108
FO 2107
a) Sealing gasket
4
5
A
15

Advertisement

loading

  Also See for Electrolux EHG 679 B

  Related Manuals for Electrolux EHG 679 B

This manual is also suitable for:

Ehg 679 w