Table of Contents
Advertisement
If you cannot light the flame even after severalattempts, check the "cap"
(see the diagram - lett. A A A A A ) and the"crown" (see the diagram - lett. B B B B B ) are
in the correct position.
Do not keep the control knob pressed for more than 15
seconds. If the burner does not light even after 15 seconds,
release the control knob, turn it the "off" position and wait for
at least one minute before trying to light the burner again.
When switching on the mains, after installation or a power cut, it is quite
normal for the spark generator to be activated automatically.
In the absence of electricity
In the absence of electricity
In the absence of electricity, ignition can occur without the electrical
In the absence of electricity
In the absence of electricity
device; in this case, approach the burner with a flame, push the relevant
knob down and turn it anti-clockwise until it reaches the maximum position.
If the control knobs become difficult to turn, please contact your local
Service Force Centre.
Using the hob correctly
Using the hob correctly
Using the hob correctly
Using the hob correctly
Using the hob correctly
To ensure maximum burner efficiency, it is strongly recommended that you
use only pots and pans with a flat
so that flame will not spread beyond the bottom of the vessel (see the table
below).
flat
flat
flat
flat bottom fitting the size of the burner used,
B u r n e r
B u r n e r
B u r n e r
B u r n e r
B u r n e r
Large (rapid)
Medium (semi-rapid)
Small (auxiliary)
m i n i m u m
m i n i m u m
m i n i m u m
m a x i m u m
m a x i m u m
m a x i m u m
m i n i m u m
m i n i m u m
m a x i m u m
m a x i m u m
d i a m e t e r
d i a m e t e r
d i a m e t e r
d i a m e t e r
d i a m e t e r
d i a m e t e r
d i a m e t e r
d i a m e t e r
d i a m e t e r
d i a m e t e r
180 mm
120 mm
80 mm
electrolux 9
260 mm
220 mm
160 mm
Advertisement
Table of Contents
