Building In; Cut Out Size; Fitting The Hob To The Worktop - Electrolux EGG 689 Instruction Booklet

Cut Out Size

The dimensions of the cut-out are given in the diagram.
FO 2098

Building In

Building over a cupboard or
drawer
If the hob is to be installed above a cupboard or drawer it
will be necessary to fit a heat resistant board below the
base of the hob on the underside of the work surface.
It is also recommended to carry out the electrical
connection to the hob as shown in diagrams 1 and 2.
Building over a kitchen unit with
door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the bottom
of the hob which can be heated when it is operated. The
recommended solution is shown in diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.

Fitting the hob to the worktop

Before fitting the hob into the cut out, an adhesive seal
must be fitted to the underside outside edge of the hob.
It is essential that no gaps are left in this seal in order to
prevent spillage near the hob seeping into the cabinet
below.
"
1) Remove the pan supports, the burners caps and
crowns and turn the hob upside down, taking care
the ignition candles are not damaged in this
operation.
2) Place the relevant sealing all around the glass
top edge, taking care that the sealings meet
without overlapping (Fig. 4).
3) Place the hob in the cut out, taking care of its
centring.
4) Fix the hob with the relevant screws (Fig. 5).
8
FO 0764
Dimensions are given in mm.
FO 2108
a) Sealing gasket
FO 0763
2
FO 1013
A
1
3
4
5