Download  Print this page

Using The Appliance; Starting The Programme; Stopping The Programme Temporarily; Cancelling The Programme - Electrolux ESF 2435 Instruction Book

Hide thumbs

Advertisement

Using the appliance

Starting the programme

1. Scrape or rinse off solid food remnants.
2. Load the dishwasher.
(See the basket and loading).
3. Put the correct amount of detergent into the
detergent dispenser and close the dispenser lid.
4. Close the door.
5. Press in the On/Off button. The lamp for the
On/Off button comes on.
6. Press in the required programme button (see pro-
gramme chart). Programme indicator lamp is lit.
During the three seconds the two top indicator
lamps are flashing, you can select another pro-
gramme cycle. If not, the selected programme
starts. The lamp allways indicates which part of
the selected cycle the dishwasher is in.
7. Check the strainers/filters to see if they need to
be cleaned when the dishwasher has finished
the programme.
If both the top and middle indicator lights are
flashing, first check that the door is properly closed,
otherwise read the section "In the event of a fault".

Stopping the programme temporarily

1. Open the door. The programme stops.
2. The programme indicator lamp is lit.
3. Close the door and the programme continues
after about six seconds.
Open the door carefully when the dishwasher is
running, since hot steam may escape.

Cancelling the programme

1. Press and hold in the combination buttons until
the indicator light for the programme goes out.
2. Release the buttons. The programme is now
cancelled and a new programme can be selected.
If you switch the dishwasher off, the selected
programme is not finished, it is only disrupted.
When you start the dishwasher again, the pro-
gramme will continue.

Pause function

With the paus function the programme can be temporarily
disrupted for a short period of time.
1. Press in the On/Off button. The programme stops.
2. All lamps goes out.
3. When you want the programme to continue again,
you press the On/Off button.
The programme continues.
The programme should not be paused for any
longer than necessary, because the water inside
the dishwasher has cooled down and must be
heated again which increases the power
consumption.

Cancelling the drying phase

In case you do not want to wait until the drying phase is
completed, you can cancel it.
1. Press in the On/Off button. The control lamp for
the On/Off button goes out.
2. Open the door. The drying phase is cancelled.

Switching the dishwasher off

Switch the dishwasher off, when the indicator lamp
for the programme cycle end is lit.
1. Press in the On/Off button. The control lamp for
the On/Off button goes out.
Be careful if you open the door immediately
after the programme is finished, since hot steam
may escape.
This dishwasher has a new feature called
"IMPULSE WASHING". This washing system
varies both the revolutions of the pump and the
water pressure for more intensive cleaning of the
dishes during a programme. That is why different
sections of the programme cycle do not sounds
the same.
- 9 -

Hide quick links:

Advertisement

loading