Building In; Electrical Connection - Electrolux ESL 590 Operating Instructions Manual

Building in

1. Stick on the damp-protection film as described in
the instructions on the rear side of the film (shorten
where necessary).
2. Attach the side rails to the side panels of the furni-
ture as described in the separate assembly in-
structions.
3. Place dishwasher in front of high cabinet. Push ca-
bles and hoses through the space for the high cabi-
net over the lower section to the next cabinet.
4. Push dishwasher into the space.
Run the cable and hoses through the high cup-
board's bay so that they are neither kinked or
squashed.
5. Align dishwasher so that it is centered and flush.
6. arefully open the dishwasher door so that it re-
mains in position. Use screws and the holes provi-
ded to fasten the dishwasher to the cabinet side
walls on both sides at the top inside (see detail A).
7. Before screwing the appliance diagonally through
the base plate using two additional screws (al-
ways pre-drill!), it is advisable to protect the ap-
pliance door from damage using suitable materials
(e-g., the cardboard packaging). In order to tigh-
ten these screws, the door must be opened by ap-
prox. 45 degrees (see Detail B).

Electrical connection

The mains connection must be carried out by
an expert electrician.
- The dishwasher is fitted with a 3 x 1 mm
ting cable and an earthed plug.
- A wire of type H05VV-F or of higher rating is to be
used as supply cable.
- The dishwasher must be installed with a cable with
a plug or there must be a disconnecting device with
at least 3 mm contact opening in the existing do-
mestic electrical installation, which disconnects
the dishwasher completely from the mains supply
in accordance with NIN 2000.
Installation on site
- Install fuse, cable and socket according to circuit
diagram.
28
2
connec-
Circuit: heating voltage 230V
Detail A
Detail B