Care and cleaning
Remove water from the steam generator with the Sponge 150 and rub dry.
Keep the door open for approximately 1 hour to let the appliance dry fully.
You can use the End function to delay start of cleaning process (refer to "Setting the END").
You can remove the shelf support to clean the side walls.
Removing the shelf support
1. Carefully pull the support up and out of
the front catch.
2. Lightly move the support on the front
3. Pull the support out of the rear catch.
Installing the shelf support
Install the shelf support in the opposite sequence.
Steam generation system
Dry the steam generator after each use . Soak up water with the Sponge 150.