Download  Print this page

Instruction For The Installer - Electrolux EHE 30200 Instruction Booklet

Built-in
Hide thumbs

Advertisement

Instruction for the Installer

Insertion and assembly
Dimensions for building in a kitchen unit are given in
Fig. 2.
The side walls of the unit must not exceed the height of
the hob. Avoid installing the appliance in the proximity
of inflammable materials (e.g. curtains, tea towels, etc.).
Before fitting the hob into the cut out, a sealing gasket
supplied with the hob must be fitted to the edge of the
cut out. It is essential that no gaps are left in this seal in
order to prevent spillage near the hob seeping into the
cabinet below.
1) Place the sealing gasket all around the edge
of the cut out.
2) Place the hob into the cut out and secure it by
means of the relevant fixing clamps and screws,
as shown in Fig.3.
3) Remove the excess seal
The edge of the hob forms a double seal which prevents
the ingress of liquids.
If several 30cm hob are to be installed side by
side into the same cut out, an assembly kit
including a support side bracket and
supplementary sealings is available at our After
Sales Centres. The relevant installation
instructions are supplied within the kit package.
6
Technical Data
Rear hotplate
Frontl hotplate
Total energy
Voltage
Hob recess dimensions
Length
Width
Fig. 2
FO 0199
Fig. 3
a) Seal
180 mm Ø
1,5 kW
145 mm Ø
1,0 kW
2,5 kW
230 V - 50 Hz
490 mm.
270 mm.
a

Advertisement

loading