Section 5: Downloading New Firmware To The Hegs5Blx; Introduction; Connecting The Hegs5Blx To Your Pc - Honeywell HEGS5BLX User Manual

DOWNLOADING NEW FIRMWARE TO THE HEGS5BLX
5.1

INTRODUCTION

New firmware for the HEGS5BLX controller can be downloaded through the RS-232 port.
This is done through a simple windows program called Ultrak Code Server.
To download the latest version of the Code Server, visit the download section on the
Honeywell website
(http://www.honeywellvideo.com/support/downloads/Downloads_keyboards.html
Select Keyboards and Controllers. Locate the HEGS5BLX and follow the instruction to
download the Ultrak Code Server.
To download the latest version of the HEGS5BLX firmware, click the latest version and
select "Open." This will open Winzip and install the firmware to the default directory
(C:\Program Files\Ultrak Code Server\CCTV\HEGS5BLX). If Code Server was installed
to a different drive, select the drive prior to installing.
5.2

CONNECTING THE HEGS5BLX TO YOUR PC

1. Connect the HEGS5BLX to COM1 or COM2 on your PC. Refer to the diagram below
for correct download cable connections.
1
6
RS-232
to PC
9
5
DB-9 Female
rear view of connector
2. Disconnect power from the HEGS5BLX. Reconnect the power and, before the boot
timer reaches zero, press 1 on the controller. This will put the controller into the
download mode.
3. Enter the Master password (if it has not been changed the default Master password
for downloading new firmware is 4991).
4. Press the LEFT (
Download
System Firmware
Rev. 1.01
SECTION 5:
RS-232 Download cable connections
) or RIGHT ( ) arrow keys until the LCD display shows
14
).
To HEGS5BLX
900.0799
20-Jun-06