Select And Start A Washing Programme - Electrolux ESF 47005 User Manual

If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the Mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Switch on the appliance. It must be in
setting mode.
2. Press and hold, at the same time, the
function buttons B and C. The pro-
gramme indicator lights above function
buttons A, B and C start flashing
3. Press function button B, the programme
indicator lights above function buttons A
and C go off. The programme indicator
light above function button B continues
to flash. The digital display shows the cur-
rent setting.

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the on/off button. The appliance
must be in setting mode.
4. Select a washing programme (see
'Washing programmes' chart).
When a programme has been selected
the corresponding light comes on.
Close the appliance door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the flashing number of hours for the delay
start appear in the digital display.
Rinse aid dispenser deactivated
Rinse aid dispenser activated
4. To change the setting, press button B
again. The digital display shows the new
setting.
5. To memorize the operation, switch off the
appliance.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:
1. Deactivate the Multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
2. Close the appliance door, the countdown
starts automatically. The number in the
display is no longer flashing but fixed with
static light.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
The selection of the washing pro-
gramme and delay start can occur also
with the door closed.
When you press a programme button
you have ONLY 3 seconds to select a
different programme or a delay start.
After these 3 seconds, the selected pro-
gramme starts automatically.
electrolux 15