HP Pavilion 14 Maintenance And Service Manual page 42

2. Remove the Phillips screw (2) that secures the WLAN module to the system board. (The WLAN
module tilts up.)
3. Remove the WLAN module by pulling the module away from the slot at an angle (3).
NOTE:
the WLAN module socket.
NOTE: If the WLAN antennas are not connected to the terminals on the WLAN module,
the protective sleeves should be installed on the antenna connectors, as shown in the following
illustration.
36 Chapter 4 Removal and replacement procedures
The WLAN module is designed with a notch to prevent incorrect installation into