Pause function
With the pause function the programme can be interrupted
for a short period of time.
1. Press in the On/Off button. The programme stops.
2. All lamps goes out.
3. When you want the programme to continue again,
you press the On/Off button. The programme
continues.
The programme should not be paused for any
longer then necessary, because the water inside
the dishwasher has cooled down and must be
heated again which increases the power
consumption.
Cancelling the drying phase
In case you do not want to wait until the drying phase is
completed, you can cancel it.
1. Press in the On/Off button.
2. Open the door. The drying phase is cancelled.
Switching the dishwasher off
Switch the dishwasher off, when the indicator lamp
for the programme cycle end is lit or the display shows 0.
1. Press in the On/Off button.
2. Leave the door slightly ajar.
Be careful if you open the door immediately
after the programme is finished, since hot
steam may escape.
This dishwasher is equipped with the new flush
system called ”IMPULSE WASHING”. This
washing system varies both the revolutions of
the pump and the water pressure for more inten-
sive cleaning of the dishes during a programme.
That is why different sections of the programme
cycle do not sound the same.
Cleaning the dishwasher
Clean the outside surfaces of the appliance using a mild
(non-abrasive) household cleaning product. Finish by
removing remaining traces of the product with a damp cloth.
Do not use cleaning products which contain
alcohol (spirits), thinners and similar sub-
stances.
Page 9