Electrical Connection - Electrolux EHD 8690 P Installation And Operating Instructions Manual

Electrical Connection

Before connecting, check that the nominal voltage of the appliance, that is
the voltage stated on the rating plate, corresponds to the available supply
voltage. The rating plate is located on the lower casing of the hob.
The heating element voltage is AC230V~. The appliance also works per-
fectly on networks with AC220V~ or AC240V~.
The hob is to be connected to the mains using a device that allows the ap-
pliance to be disconnected from the mains at all poles with a contact open-
ing width of at least 3 mm, eg. automatic line protecting cut-out,earth
leakage tripsorfuse.
A cable with minimum temperature rating of V90HT or one with a higher
grade must be used as the mains connecting cable.
The connection must be carried out as shown in the diagram. The connect-
ing links should be fitted according to the appropriate connection diagram.
The earth lead is connected to terminal E. The earth lead must be longer
than leads carrying electric current.
The cable connections must be made in accordance with regulations
and the terminal screws tightened securely.
Finally, the connecting cable is to be secured with the mains cable cleat and
the covering closed by pressing firmly (lock into place).
Before switching on for the first time, any protective foil or stickers must be
removed from the glass ceramic surface.
1
Once connected to the mains supply check that all cooking zones are ready
for use by briefly switching each on in turn at the maximum setting.
Sticking on the seal
• Clean the worktop around the cut-out area.
• Stick the single-sided adhesive sealing tape provided on the underside of
the hob around the outside edge ensuring that it is not stretched. The two
ends of the tape should join in the middle of one side. After trimming the
tape (allow it to overlap by 2-3 mm), press the two ends together.
25