Defrosting The Freezer; To Change The Light Bulb; When The Appliance Is Not In Use; Something Not Working - Electrolux EUC2609 Instruction Book

Table of Contents

Advertisement

Defrosting the freezer

A certain amount of frost will always form on the
freezer shelves and around the top compartment.
Defrost the freezer when the frost layer reaches a
thickness of about 3-5 mm.
Remove the freezer drawers and place them on top
of each other by turning every other drawer one half
turn. Put insulating material around the drawers, e.g.
blankets or newspapers.
The frozen products can also be packed closely
together and be kept in a cold location, e.g. in the
fridge.
Defrosting can be accelerated by placing bowls with
hot water (not boiling) inside the freezer.
Loosen the drainage channel from its resting
position and push in according to the illustration and
place it in the bottom freezer drawer where water can
collect.
Carefully scrape off the ice when it starts to thaw.
Use a wood or plastic scraper. Do not use sharp
objects as these may damage the interior.
When all the ice has melted, clean and wipe the
cabinet dry, then put the drainage channel back in
place.
Switch on the cabinet and replace the frozen
foodstuff.

To change the light bulb

The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Cut the packaging around the bulb socket.
Keep the packaging on to hold the bulb when setting
it into the socket. Do not touch the bulb with your
bare fingers. Halogen light bulbs are sensitive to
grease from the skin.
Use a clear halogen light bulb.

When the appliance is not in use

Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.

Something Not Working

Before contacting your local Service Force Centre check the following point:
Problem
" " is displayed in the temperature
display.
Or
The yellow Action Freeze and red
warning lamp both flash.
Never use a hair drier or other heating
appliances to speed up defrosting. Excessive
heat may damage the plastic interior, and
humidity could enter the electric appliance
making it live.
G4
20W/12V
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside
from spoiling in case of a power failure.
Possible cause / Remedy
An error has occurred in measuring the temperature. Call your
service representative. (The cooling system will continue to
keep food products cold, but temperature adjustment will not
be possible.)
45
UV-blocked
Low pressure
GB
Electrolux 818 33 65-01/7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Euc3009

Table of Contents