Power Saver Switch; Temperature Controls - GE ZS48N Use And Care Manual

48” built-in refrigerator
Table of Contents

Advertisement

Set Temperature Controls
Your refrigerator has two
controls that let you regulate the
temperature in the fresh food and
freezer compartments.
They have settings from 1 through
9, and are located at the top of the
fresh food compartment.
The freezer control also has
an OFF setting.
9 is the coldest setting, 1 is the wa
How to Test Temperatures
Use the milk test for the fresh
food compartment. Place a
container of milk on the top shelf
in the fresh food compartment.
Check it a day later. If the milk is
too warm or too cold, adjust the

temperature controls.

Power Saver Switch

The power saver switch is located
on the temperature control panel.
To reduce the amount of electricity required
to operate your refrigerator, push switch to
POWER SAVER setting.
This turns off the heater in your refrigerator that
prevents moisture from forming on the outside of the
refrigerator.
With the heater turned off, there is a chance that
moisture may form on the outside of your refrigerator,
especially when the weather is humid.
The humidity is most likely to be high in the summer,
in the early morning hours, and in homes which are
not air conditioned.
No Defrosting
It is not necessary to defrost the freezer or fresh food
compartments. Although your refrigerator is designed
and equipped to defrost itself automatically, some
frost on packages is normal.
WHEN YOU FIRST TURN THE REFMGERATOR
ON, SET BOTH CONTROLS AT 5.
For colder or warmer temperatures, adjust the desired
compartment control one number at a time.
FRESH FOOO
IMPORTANT: When first settin~ controls. or
adjusting them, allow 24 hours for the refrigerator
to get cold.
5 IS NORMAL
NOTE: Turning the freezer control to the OFF
91 SCOLDEST
position stops cooling in BOTH compartments—
FREEZER
fresh food AND freezer—but does not shut off
power to the refrigerator.
freezer compartment. Place a
center of the freezer compartment.
Check it after a day. If it's too
hard or too soft, adjust the
temperature controls.
Over an extended period of time, moisture that forms
on the refrigerator surface may cause deterioration of
the paint finish. It will be important to protect the
finish by using appliance polish wax as described in
the Care and Cleaning section.
Move the power saver switch from the POWER
SAVER setting and electricity flows through the low
wattage heater which warms the outside of the
refrigerator. Under most conditions, this prevents the
forming of moisture or water droplets.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents