NEC Univerge DT310 User Manual page 49

Using the Headset with Automatic Answer for
ACD Agents:
1. With the multiline terminal in an idle state, press the
Feature key.
2. Press the HEADSET key (Code 05).
The Headset key blinks when Automatic
Note:
Headset is activated.
Note: To cancel Automatic Headset, repeat these
steps.
Station Speed Dial – Dial Access
To store a Station Speed Dialing number (display
telephones only):
1. Press the Speaker key.
2. Dial 755.
3. Dial the Station Speed Dial buffer number to be
programmed (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
:
:
0 = Station Speed Dial buffer 10
4. Dial the Access Code (e.g., 9) – if required.
5. Dial telephone number you want to store (up to 24
digits including 0 for outside line).
Note:
Valid entries are 0~9, # and *. To enter a pause,
press MIC. To store a Flash, press Recall.
6. Press Hold.
7. Enter the name associated with the Speed Dialing
number (display telephones only):
Use this
keypad
digit....
1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ
2
Enter characters: A-C, a-c 2
3
Enter characters: D-F, d-f, 3
4
Enter characters: G-I, g-I, 4
5
Enter characters: J-L, j-l, 5
6
Enter characters: M-O, m-o, 6
7
Enter characters: P-S, p-s, 7
8
Enter characters: T-V, t-v,8
9
Enter characters: W-Z, w-z,9
0
Enter characters:
0 ! " # $ % & ' ( ) ô Õ ú ä ö ü á å è
*
Enter characters:
+ , - . / : ; < = > ? B E ó S ¢ £
#
# = Accepts an entry (only required if
two letters on the same key are needed
– ex: TOM). Pressing # again = Space.
Conf
Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Name).
Exit
Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Number, this
clears both the number and name).
43
Key for Entering Names
When you want to....
¨
Á À Â Ã Ç É Ê ì ó