Monogram 36 Owner's Manual page 11

Ice storage To remove:
Lift up the access door to reach the icemaker.
bin
Set the icemaker power switch to the O (off)
position. With the access door closed, support
the storage bin at the bottom while slightly
lifting. Pull bin straight out.
To replace:
Slide the bin back until the tab on the bin
locks into the slot on the shelf. If the bin
does not go all the way back, remove it and
rotate the drive mechanism 1/4 turn. Then
push the bin back again.
Important • Do not add ice from trays or bags to the
facts about
your ice • Avoid overfilling glass with ice and use of
& water
dispenser
• Beverages and foods should not be
• To keep dispensed ice from missing
storage bin. It may not crush or dispense well.
narrow or extra-tall glasses. Backed-up ice
can jam the chute or cause the door in the
chute to freeze shut. If ice is blocking the
chute, poke it through with a wooden spoon.
quick-chilled in the ice storage bin.
Cans, bottles or food packages in the
storage bin may cause the icemaker
or auger to jam.
the glass, put the glass close to, but not
touching, the dispenser opening.
Access Door
Ice Storage Bin
Drive
Mechanism
• Some crushed ice may be dispensed even
though you selected CUBES. This happens
occasionally when a few cubes accidentally
get directed to the crusher.
• After crushed ice is dispensed, some water
may drip from the chute.
• Sometimes a mound of snow will form on
the door in the ice chute. This condition is
normal and usually occurs when you have
dispensed crushed ice repeatedly. The snow
will eventually evaporate.
• Dispensed water is not ice cold. For colder
water, simply add crushed ice or cubes
before dispensing water.
• The first glass of water dispensed may be
warmer than the following ones. This is
normal.
Rotate
11