Programme Knob - Electrolux ESF6200LOW User Manual

Hide thumbs Also See for ESF6200LOW:
Table of Contents

Advertisement

Available languages

Available languages

14 www.electrolux.com
WARNING!
Deactivate the appliance before
you do the checks. Turn the knob
until the programme marker is
aligned with the on/off indicator.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The appliance does not drain the
water.
The anti-flood device is on.
After the checks are completed, turn the
programme knob until the programme
marker is aligned with programme that
was in operation when the problem oc-
curred. The programme continues from
the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes show, contact the
Service.
9.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse in
the fuse box.
Make sure that the appliance door is closed.
Press Start.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Make sure that the inlet hose has no kinks or
bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or
bends.
Close the water tap and contact the Service.
• The quantity of detergent is too much.
Stains and dry water drops on
glasses and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
Refer to 'HINTS AND TIPS' for
other possible causes.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents