Electrolux ECG6200 Instruction Book page 66

g
preparation of next coffee (see „Set-
ting the grinding texture", page 60).
• Wrong type of coffee.
0 Use a type of coffee for fully auto-
mated espresso makers.
The coffee runs out too slowly
• The coffee is ground too finely.
0 Turn the knob for setting grinding tex-
ture one click clockwise whilst the
grinder is grinding beans for the prep-
aration of next coffee (see „Setting the
grinding texture", page 60).
The coffee runs out too quickly
• The coffee is ground too coarsely.
0 Turn the knob for setting grinding tex-
ture one click anticlockwise whilst the
grinder is grinding beans for the prep-
aration of next coffee (see „Setting the
grinding texture", page 60).
The coffee flows out of only one of
the dispensers
• The dispenser holes are blocked.
0 Scrape off the dry coffee residues with
a needle (Fig. 29).
When the knob for steam and hot
water is turned, no steam comes out
of the steam nozzle
• The holes in the steam nozzle and the
inner part of the steam nozzle are
clogged.
0 Clean the holes in the steam nozzle
and the inner part of the steam nozzle
(see „Cleaning the steam nozzle",
page 59).
When the or
selected, the appliance does not
deliver coffee, but only water
• The ground coffee may be blocked in
the ground coffee filler.
0 Remove the ground coffee inside the
filler using a knife (see „Using pre-
ground coffee", page 58) (Fig. 22). Then
clean the brewing unit and the inside
of the appliance (see „Cleaning the
brewing unit", page 62)
66
• The main switch at the back is not
0 Check that the main switch is in the "I"
• The appliance is on. The brewing unit
0 Turn the appliance off and remove the
3
• The holes in the dispenser outlets are
0 Remove the dried coffee with a needle
• The tilt compartment (R) inside the ser-
0 Thoroughly clean the tilt compartment,
function is
• Too much ground coffee has been
0 Remove the brewing unit and thor-
When the button is pressed, the
appliance does not switch on
switched on (fig. 8) or the appliance is
not plugged in.
position and that the power cable is
plugged into the mains socket.
The brewing unit cannot be removed
for cleaning
can only be removed if the appliance is
off.
brewing unit (see „Cleaning the brew-
ing unit", page 62).
Important: The brewing unit can only
be removed if the appliance is turned
off with the ON/OFF key
front. It should not be disconnected
from the mains. Attempting to
remove the brewing unit when the
appliance is on may cause serious
damage.
The coffee does not run out from
the dispenser outlets, but from
around the sides of the service door
clogged with dry coffee.
(Fig. 29).
vice door is blocked and cannot swing.
particularly near the hinges, to ensure
they are free to swing smoothly.
Ground coffee was used (not beans)
and the appliance does not deliver
any coffee
added.
oughly clean the inside of the appli-
ance, as described in „Cleaning the
brewing unit", page 62. Repeat the
operation using a maximum of 2
scoops of ground coffee.
at the