GE 36, 48 Use And Care Manual page 9

Stainless steel professional 27", 36" & 48" outdoor cooking center
Hide thumbs Also See for 36, 48:
Table of Contents

Advertisement

Before
WARNING: IMPORTANT!
lighting
Inspect the gas supply piping or hose prior to
the grill
turning the gas on. If there is evidence of cuts,
wear or abrasion, it must be replaced prior to
use. Any replacement pressure regulators or
hose assembly must be the type specified by the
manufacturer.
For LP use, the pressure regulator and hose
assembly supplied with the unit must be used.
This LP tank is equipped with overfill
protection. When you refill or trade in your
tank, make sure the one you receive also has
overfill protection.
To light
Always keep your face and body as far away from the
the grill
grill as possible when lighting.
Open the lid, push and turn the grill control
knob to the LITE position and immediately
turn the rotary igniter knob of the spark igniter
next to the grill control knob. You'll hear a
snapping sound. At the same time a spark will
be provided at the grill burner.
It may be necessary to turn the rotary igniter
knob several times until the burner is lit.
If the burner does not light in 4 seconds,
turn both knobs to OFF and wait 5 minutes,
for any accumulated gas to dissipate, before
trying again.
If the burner will not light after several attempts
the burner can be match lit. Remove the grill
rack over the burner(s) you wish to light. If
you've just attempted to light the burner with
the igniter, allow 5 minutes for any
accumulated gas to dissipate. Keep your face as
far away from the grill as possible and pass a lit,
long stem match through the lava radiant and
position it near the burner ports. Make sure that
the match is adjacent to the burner ports. Push
and turn the control knob, which is centered on
the burner you wish to light, to LITE. If the
burner does not light in 4 seconds turn the
knob OFF. Wait 5 minutes and try again. If the
burner will not light after several attempts, see
the Problem Solver in the back of this guide.
NOTE:
• Do not attempt to light the grill if the odor of
gas is present. Call for service.
• Always wait 5 minutes before relighting a
hot grill.
If the grill uses LP gas, connect the regulator to
the LP tank and check the hose and regulator
connections for leaks with a soap and water
solution before operating the grill.
Keep a spray bottle of soapy water near the gas
supply valve and check the connections for gas
leaks before each use.
Turn all knobs to OFF then turn on the gas
supply.
Do not use the grill if the odor of gas is present.
Grill control knob
Each grill burner has its own rotary igniter. The igniter knob is
located to the immediate right of the control knob.
Rotary igniter knob
9

Advertisement

Table of Contents
loading

Table of Contents