Configuring Multicast Source Port Filtering - HP 4800G Series Configuration Manual

Configuring a multicast group filter globally
Follow these steps to configure a multicast group filter globally:
To do...
Enter system view
Enter IGMP Snooping view
Configure a multicast group
filter
Configuring a multicast group filter on a port or a group of ports
Follow these steps to configure a multicast group filter on a port or a group of ports:
To do...
Enter system view
Enter Ethernet port/Layer 2
aggregate port view or port
group view
Configure a multicast group
filter

Configuring Multicast Source Port Filtering

With the multicast source port filtering feature enabled on a port, the port can be connected with
multicast receivers only rather than with multicast sources, because the port will block all multicast data
packets while it permits multicast protocol packets to pass.
If this feature is disabled on a port, the port can be connected with both multicast sources and multicast
receivers.
Configuring multicast source port filtering globally
Follow these steps to configure multicast source port filtering globally:
To do...
Enter system view
Enter IGMP Snooping view
Enable multicast source port
filtering
Use the command...
system-view
igmp-snooping
group-policy acl-number
[ vlan vlan-list ]
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
igmp-snooping group-policy
acl-number [ vlan vlan-list ]
Use the command...
system-view
igmp-snooping
source-deny port interface-list
1-15
Remarks
—
—
Required
By default, no group filter is
globally configured, that is,
hosts in VLANs can join any
valid multicast group.
Remarks
—
Required
Use either approach
Required
By default, no group filter is
configured on the current port,
that is, hosts on this port can
join any valid multicast group.
Remarks
—
—
Required
Disabled by default