Configuring Ospfv3 Inbound Route Filtering; Configuring An Ospfv3 Cost For An Interface - HP 4800G Series Configuration Manual

Follow these steps to configure route summarization:
To do...
Enter system view
Enter OSPFv3 view
Enter OSPFv3 area view
Configure a summary route
The abr-summary command takes effect on ABRs only.

Configuring OSPFv3 Inbound Route Filtering

You can configure OSPFv3 to filter routes that are computed from received LSAs according to some
rules.
Follow these steps to configure OSPFv3 inbound route filtering:
To do...
Enter system view
Enter OSPFv3 view
Configure inbound route
filtering
Use of the filter-policy import command can only filter routes computed by OSPFv3. Only routes not
filtered out can be added into the local routing table.

Configuring an OSPFv3 Cost for an Interface

You can configure an OSPFv3 cost for an interface with one of the following two methods:
Configure the cost value in interface view.
Configure a bandwidth reference value for the interface, and OSPFv3 computes the cost
automatically based on the bandwidth reference value: Interface OSPFv3 cost = Bandwidth
reference value/Interface bandwidth. If the calculated cost is greater than 65535, the value of
65535 is used.
If the cost value is not configured for an interface, OSPFv3 computes the interface cost value
automatically
Use the command...
system-view
ospfv3 [ process-id ]
area area-id
abr-summary ipv6-address
prefix-length [ not-advertise ]
Use the command...
system-view
ospfv3 [ process-id ]
filter-policy { acl-number |
ipv6-prefix ipv6-prefix-name } import
1-8
Remarks
—
—
—
Required
Not configured by default
Remarks
—
—
Required
Not configured by default