HP 4800G Series Configuration Manual page 350

To do...
Disable the RA message
suppression
Configure the maximum and
minimum intervals for
sending RA messages
Configure the prefix
information in RA messages
Set the M flag bit to 1
Set the O flag bit to 1
Configure the router lifetime
in RA messages
Set the NS retransmission
timer
Set the reachable time
Use the command...
undo ipv6 nd ra halt
ipv6 nd ra interval
max-interval-value
min-interval-value
ipv6 nd ra prefix
{ ipv6-address prefix-length |
ipv6-address/prefix-length }
valid-lifetime preferred-lifetime
[ no-autoconfig | off-link ] *
ipv6 nd autoconfig
managed-address-flag
ipv6 nd autoconfig other-flag
ipv6 nd ra router-lifetime
value
ipv6 nd ns retrans-timer
value
ipv6 nd nud reachable-time
value
1-14
Remarks
Required
By default, RA messages are
suppressed.
Optional
By default, the maximum interval
for sending RA messages is 600
seconds, and the minimum
interval is 200 seconds.
The device sends RA messages
at random intervals between the
maximum interval and the
minimum interval.
The minimum interval should be
less than or equal to 0.75 times
the maximum interval.
Optional
By default, no prefix information is
configured for RA messages, and
the IPv6 address of the interface
sending RA messages is used as
the prefix information.
Optional
By default, the M flag bit is set to
0, that is, hosts acquire IPv6
addresses through stateless
autoconfiguration.
Optional
By default, the O flag bit is set to
0, that is, hosts acquire other
information through stateless
autoconfiguration.
Optional
1800 seconds by default.
Optional
By default, the local interface
sends NS messages at an interval
of 1000 milliseconds, and the
value of the Retrans Timer field in
RA messages sent by the local
interface is 0.
Optional
By default, the neighbor
reachable time on the local
interface is 30000 milliseconds,
and the value of the Reachable
Timer field in RA messages is 0.