To do...
Enable local proxy ARP
Displaying and Maintaining Proxy ARP
To do...
Display whether proxy ARP is
enabled
Display whether local proxy
ARP is enabled
Proxy ARP Configuration Examples
Proxy ARP Configuration Example
Network requirements
Host A and Host D have the same IP prefix and mask. Host A belongs to VLAN 1; Host D belongs to
VLAN 2. Configure proxy ARP on the switch to enable the communication between the two hosts.
Figure 2-3 Network diagram for proxy ARP
Configuration procedure
# Configure Proxy ARP on Switch to enable the communication between Host A and Host D.
<Switch> system-view
[Switch] vlan 2
[Switch-vlan2] quit
[Switch] interface vlan-interface 1
[Switch-Vlan-interface1] ip address 192.168.10.99 255.255.255.0
[Switch-Vlan-interface1] proxy-arp enable
Use the command...
local-proxy-arp enable
Use the command...
display proxy-arp [ interface
vlan-interface vlan-id ]
display local-proxy-arp [ interface
vlan-interface vlan-id ]
2-3
Remarks
Required
Disabled by default.
Remarks
Available in any view
Available in any view