HP 4800G Series Configuration Manual page 1633

# Configure Track object 1, and associate it with Reaction entry 1 of the NQA test group (with the
administrator admin, and the operation tag test).
[SwitchA] track 1 nqa entry admin test reaction 1
5) Verify the configuration
# Display information of the Track object on Switch A.
[SwitchA] display track all
Track ID: 1
Status: Positive
Reference object:
NQA entry: admin test
Reaction: 1
# Display the routing table of Switch A.
[SwitchA] display ip routing-table
Routing Tables: Public
Destinations : 5
Destination/Mask
10.1.1.0/24
10.2.1.0/24
10.2.1.2/32
127.0.0.0/8
127.0.0.1/32
The output information above indicates the NQA test result, that is, the next hop 10.2.1.1 is reachable
(the status of the Track object is Positive), and the configured static route is valid.
# Remove the IP address of interface VLAN-interface 3 on Switch B.
<SwitchB> system-view
[SwitchB] interface vlan-interface 3
[SwitchB-Vlan-interface3] undo ip address
# Display information of the Track object on Switch A.
[SwitchA] display track all
Track ID: 1
Status: Negative
Reference object:
NQA entry: admin test
Reaction: 1
# Display the routing table of Switch A.
[SwitchA] display ip routing-table
Routing Tables: Public
Destinations : 4
Destination/Mask
10.2.1.0/24
10.2.1.2/32
Routes : 5
Proto Pre Cost
Static 60 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Routes : 4
Proto Pre Cost
Direct 0 0
Direct 0 0
1-10
NextHop Interface
10.2.1.1 Vlan3
10.2.1.2 Vlan3
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
NextHop Interface
10.2.1.2 Vlan3
127.0.0.1 InLoop0