Acl Assignment Configuration Example - HP 4800G Series Configuration Manual

[Device-radius-2000] primary accounting 10.11.1.1 1813
[Device-radius-2000] key authentication abc
[Device-radius-2000] key accounting abc
[Device-radius-2000] user-name-format without-domain
[Device-radius-2000] quit
# Configure authentication domain system and specify to use RADIUS scheme 2000 for users of the
domain.
[Device] domain system
[Device-isp-system] authentication default radius-scheme 2000
[Device-isp-system] authorization default radius-scheme 2000
[Device-isp-system] accounting default radius-scheme 2000
[Device-isp-system] quit
# Enable 802.1X globally.
[Device] dot1x
# Enable 802.1X for port GigabitEthernet 1/0/2.
[Device] interface GigabitEthernet 1/0/2
[Device-GigabitEthernet1/0/2] dot1x
# Set the port access control method to portbased.
[Device-GigabitEthernet1/0/2] dot1x port-method portbased
# Set the port access control mode to auto.
[Device-GigabitEthernet1/0/2] dot1x port-control auto
[Device-GigabitEthernet1/0/2] quit
# Create VLAN 10.
[Device] vlan 10
[Device-vlan10] quit
# Specify port GigabitEthernet 1/0/2 to use VLAN 10 as its guest VLAN.
[Device] dot1x guest-vlan 10 interface GigabitEthernet 1/0/2
You can use the display current-configuration or display interface GigabitEthernet 1/0/2 command
to view your configuration. You can also use the display vlan 10 command in the following cases to
verify whether the configured guest VLAN functions:
When no users log in.
When a user fails the authentication.
When a user goes offline.
After a user passes the authentication successfully, you can use the display interface
GigabitEthernet 1/0/2 command to verity that port GigabitEthernet 1/0/2 has been added to the
assigned VLAN 5.

ACL Assignment Configuration Example

Network requirements
As shown in Figure
802.1X authentication to access the Internet.
Configure the RADIUS server to assign ACL 3000.
1-14, a host is connected to port GigabitEthernet 1/0/1 of the device and must pass
1-20