Westerbeke 12C-TWO Operators Manual And Installation Manual page 65

5. Adjust the alternator and water pump drive belt tension, ifrequired.
6. Lubricate the throttle, the RUN linkage cable, and the transmission's remote control cable.
7. Change the transmission's transmission lubricant.
8. Adjust the engine's idle speed (1000-1200 rpm).
Servicing After Every 100 Hours of Operation
1. Change the engine's lubrication oil and oil filter.
2. Adjust the alternator and water pump drive belt tension, if required.
Servicing After Every 250 Hours of Operation
Replace the fuel filter elements in the on-engine fuel filter and in the optional water/sediment separator.
Servicing After Every 500 Hours of Operation
*
1. Torque the cylinder head hold-down bolts.
*2. Adjust the valve clearances.
*3. Drain, flush, and refill the fresh water cooling system.
*4. Check the condition of the starter motor drive pinion; lubricate pinion.
5. Check the resistance of the glow plugs. (0.16 ohm)
NOTE: Items marked by an asterisk
(*)
should be performed by a competent mechanic.
6. Check the condition of the sea water pump. Examine the pump's impeller and other pump components
for wear. Replace worn components as needed. Check for leaks and repair as needed; DO NOT
NEGLECT!
7. Check internal and external condition of water injected elbow. Remove any carbon or corrosion build-
up. Replace the elbow should its condition be questionable.
65
Westerbeke Engines