Remote Fax Commands - Brother MFC-J650DW Advanced User's Manual

Remote Fax commands

Follow the commands in the table to access features when you are away from the machine. When
you call the machine and enter your remote access code (3 digits followed by ), the system will
give two short beeps and you must enter a remote command.
Remote commands
95 Change the Fax Forwarding or Fax
Storage settings
1 OFF
2 Fax Forwarding
4 Fax Forwarding number
6 Fax Storage
96 Retrieve a fax
2 Retrieve all faxes
3 Erase faxes from the memory
97 Check the receiving status
1 Fax
98 Change the Receive Mode
1 External TAD
2 Fax/Tel
3 Fax Only
90 Exit
Operation details
You can choose Off after you have retrieved or erased all
your messages.
One long beep means the change is accepted. If you hear
three short beeps, the change was not accepted because
something has not been set up (for example, a Fax
Forwarding number has not been registered). You can
register your Fax Forwarding number by entering 4. (See
Changing your Fax Forwarding number on page 26.) Once
you have registered the number, Fax Forwarding will work.
Enter the number of a remote fax machine to receive stored
fax messages. (See Retrieving fax messages on page 26.)
If you hear one long beep, fax messages have been erased
from the memory.
You can check whether your machine has received any
faxes. If yes, you will hear one long beep. If no, you will hear
three short beeps.
If you hear one long beep, your change has been accepted.
Pressing 9 0 allows you to exit remote retrieval. Wait for the
long beep, then replace the handset.
Receiving a fax (MFC models)
4
4
25