Connections Settings; Recording An Outgoing Message (Ogm) On An External Tad; Multi-Line Connections (Pbx) - Brother MFC-J4510DW Basic User's Manual

Chapter 6
IMPORTANT
DO NOT connect a TAD elsewhere on the
same telephone line.

Connections settings

The external TAD must be connected as
shown in the previous illustration.
a
Using both hands, use the finger holds
on each side of the machine to lift the
scanner cover into the open position.
b
Carefully guide the telephone line cord
into the cable channel and out the back
of the machine.
c
Lift the scanner cover to release the
lock. Gently push the scanner cover
support down and close the scanner
cover using both hands.
d
Set your external TAD to one or two
rings. (The machine's Ring Delay setting
does not apply.)
e
Record the outgoing message on your
external TAD.
f
Set the TAD to answer calls.
g
Set the Receive Mode to
External TAD. (See Choose the
Receive Mode on page 53.)
64
Recording an outgoing
message (OGM) on an
external TAD
Timing is important in recording this
message.
6
a
Record 5 seconds of silence at the
beginning of your message. (This allows
your machine time to listen for the fax
CNG tones of automatic transmissions
before they stop.)
b
Limit your speaking to 20 seconds.
NOTE
We recommend beginning your OGM with
an initial 5 second silence because the
machine may not hear the fax tones over
a voice. You may try omitting this pause,
but if your machine has trouble receiving,
then you must re-record the OGM to
include it.

Multi-line connections (PBX)

We suggest you ask the company who
installed your PBX to connect your machine.
If you have a multi-line system, we suggest
you ask the installer to connect the unit to the
last line on the system. This prevents the
machine being activated each time the
system receives telephone calls. If all
incoming calls will be answered by a
switchboard operator, we recommend that
you set the Receive Mode to Manual.
We cannot guarantee that your machine will
operate correctly under all circumstances
when connected to a PBX. Any difficulties
with sending or receiving faxes should be
reported first to the company who handles
your PBX.
NOTE
Make sure the Telephone Line Type is set
to PBX. (See Setting the Telephone Line
Type on page 62.)
6
6