Dial Tone Detection; Telephone Line Interference / Voip - Brother MFC-J4510DW Basic User's Manual

Dial Tone detection

When you send a fax automatically, by
default your machine will wait for a fixed
amount of time before it starts to dial the
number. By changing the Dial Tone setting to
Detection, you can make your machine
dial as soon as it detects a dial tone. This
setting can save a small amount of time when
sending a fax to many different numbers. If
you change the setting and start having
problems when dialling, you should change it
back to the No Detection setting.
a
Press .
b
Press All Settings.
c
Swipe up or down, or press a or b to
display Initial Setup.
d
Press Initial Setup.
e
Swipe up or down, or press a or b to
display Dial Tone.
f
Press Dial Tone.
g
Press Detection or No Detection.
h
Press .
132
Telephone line
B
interference / VoIP
If you are having problems sending or
receiving a fax due to possible interference
on the telephone line, you can change the
compatibility setting which reduces the
modem speed to minimise errors.
a
Press
b
Press All Settings.
c
Swipe up or down, or press a or b to
display Initial Setup.
d
Press Initial Setup.
e
Swipe up or down, or press a or b to
display Compatibility.
f
Press Compatibility.
g
Press High, Normal or
Basic(for VoIP).
 Basic(for VoIP) cuts the
modem speed to 9,600 bps and
turns off colour fax receiving and
ECM, except for colour fax-sending.
Unless interference is a recurring
problem on your telephone line, you
may prefer to use it only when
needed.
To improve compatibility with most
VoIP services, Brother recommends
changing the compatibility setting to
Basic(for VoIP).
 Normal sets the modem speed at
14,400 bps.
 High increases the modem speed to
33,600 bps. (factory default)
h
Press .
NOTE
VoIP (Voice over IP) is a type of phone
system that uses an internet connection,
rather than a traditional phone line.
.
B