Speaker Setup (Htp-Fs500); Safety Precautions When Setting Up; Home Theater Sound Setup; Preparing The Speakers - Pioneer HTP-700 Operating Instructions Manual

01

Speaker Setup (HTP-FS500)

Chapter 1-3
Speaker Setup (HTP-FS500)
Safety precautions when
setting up
When assembling the speakers, lay them down
flat on their side to avoid accidents or injury.
Make sure to use a stable surface when
assembling, setting up, and placing the
speakers.

Home theater sound setup

This is a standard speaker setup. The front left
and right speakers should be about 1.8 m to 2.7
m apart.
Front left

Preparing the speakers

1 Attach the non-skid pads to the base of
receiver subwoofer.
Use the supplied adhesive to attach four pads
to the base of subwoofer.
22
En
Front right
Subwoofer
Non-skid pads
2 Insert the pole from the holes behind the
base and secure with the 4 screws.
Caution
• Be careful not to tighten screws excessively.
• If excessive force is used to tighten screws,
the threads of screw and/or nut may be
damaged. Use a middle-sized manual
screwdriver during assembly.
• Do not use power screwdrivers or oversized
screwdrivers that may exert excessive force
on the screws and nuts.
• Confirm that no foreign matter is stuck to
the stand base or the tall speaker during
assembly.
• If the unit is assembled with foreign matter
stuck between the stand base and the tall
speaker the unit may not be assembled
securely, resulting in tipping or falling.
3 Affix the gasket to the pole.
Affix the gasket to the surface of the pole where
the speaker will be mounted.