Command Edit - H3C S5100-SI Operation Manual

Table 5-5 Common error messages
Unrecognized command
Incomplete command
Too many parameters
Ambiguous command
Wrong parameter
found at '^' position

Command Edit

The CLI provides basic command edit functions and supports multi-line editing. The maximum
number of characters a command can contain is 254.
Table 5-6 Edit operations
A common key
Backspace key
Left arrow key or <Ctrl+B>
Right arrow key or <Ctrl+F>
Up arrow key or <Ctrl+P>
Down arrow key or <Ctrl+N>
<Tab>
Error message
Press...
The command does not exist.
The keyword does not exist.
The parameter type is wrong.
The parameter value is out of range.
The command entered is incomplete.
The parameters entered are too many.
The parameters entered are ambiguous.
A parameter entered is wrong.
An error is found at the '^' position.
Table 5-6
Insert the corresponding character at the cursor position
and move the cursor one character to the right if the
command is shorter than 254 characters.
Delete the character on the left of the cursor and move the
cursor one character to the left.
Move the cursor one character to the left.
Move the cursor one character to the right.
Display history commands.
Use the partial online help. That is, when you input an
incomplete keyword and press <Tab>, if the input
parameter uniquely identifies a complete keyword, the
system substitutes the complete keyword for the input
parameter; if more than one keywords match the input
parameter, you can display them one by one (in complete
form) by pressing <Tab> repeatedly; if no keyword
matches the input parameter, the system displays your
original input on a new line without any change.
5-10
Remarks
lists the CLI edit operations.
To...