Configuring Member Devices - H3C S5100-SI Operation Manual

Operation
Configure a shared FTP server
for the cluster
Configure a shared TFTP
server for the cluster
Configure a shared logging
host for the cluster
Configure a shared SNMP host
for the cluster
Configuring the network management interface for a cluster
This feature is only applicable to S5100-EI series switches.
1) Configuration prerequisites
The cluster switches are properly connected;
The shared servers are properly connected to the management switch.
2) Configuration procedure
Table 2-12 Configuring the network management interface for a cluster
Operation
Enter system view
Enter cluster view
Configure the network
management (NM) interface for
the cluster

Configuring Member Devices

Member device configuration tasks
Table 2-13 Member device configuration tasks
Enabling NDP globally and on specific ports
Enabling NTDP globally and on a specific port
Command
ftp-server ip-address
tftp-server ip-address
logging-host ip-address
snmp-host ip-address
Command
system-view
cluster
nm-interface Vlan-interface
vlan-id
Operation
2-13
Description
Optional
By default, the management
device acts as the shared FTP
server.
Optional
By default, no shared TFTP
server is configured.
Optional
By default, no shared logging
host is configured.
Optional
By default, no shared SNMP
host is configured.
Description
—
—
Required
By default, the management
VLAN interface is used as the
NM interface.
Description
Required
Required